Installation of panels and insulation layer of steel structure factory house

At present, there are many large, diverse and complex steel structures and civil buildings in many places of our country. As a new architectural pattern, steel structure workshop sweeps traditional architectural pattern with a strong attitude. The emergence of steel structure standard workshop is of great help to some manufacturers. For example, the seismic performance and open space of the standard steel structure meet the needs of the factory.

Concrete construction process of steel structure workshop:

1. Hoisting of main structure of steel structure factory: ground splicing steel beam, erection of steel column, hoisting of steel beam, connection of sub-structure, correction of main structure deviation, installation of lifting beam (optional), hoisting of interlayer (optional), and coating of fireproof coating. The main structure deviation of steel structure factory should meet the specification and design requirements, and the initial termination of high strength bolts should meet the requirements.

2. Secondary structural installation of steel structure workshop: roof wall purlin, roof wall support, flange support, etc.

3. Steel structure factory housing panel and insulation layer installation: first lay insulation layer, and then install the roof board (some projects are still laid under the insulation layer steel wire mesh, to prevent the insulation layer from falling off, mainly depends on the insulation layer level). The roof is mainly waterproof. Therefore, it is necessary to overlap the billboard with the board, nail board, glue should be full but not satisfied, glue should be cleaned, plate surface coating should not be damaged, prevent corrosion and so on.

4. Maintenance and installation of steel structure workshop's own wall: mainly installing wall insulation layer and wall panel. The walls are mainly beautiful and waterproof in the window area. There is also the question of determining whether the installation is biased. For example, the bottom should be flat, the whole plane should be flat, and the flatness deviation between the plates should meet the requirements.

5. Steel structure standard workshop detail structure: mainly some decoration and installation, such as the corner between the roof and the wall, corner, waterproof board between the wall and brick wall, door and window decoration, etc.. Detail structure is a link of hairdressing project, also be one of main component, so horizontal, plane and vertical are basic.